How to Replace a Nissan Juke Spare Key
Nissan Juke is a fun and stylish hatchback, with an unusual engine setup. It can be a bit noisy, but it's still enjoyable to drive.
Replace the key fob battery of your Nissan Juke every two years, or when it's low. It's easy to do at home, but you'll need a few tools.
Dead Coin Battery
If the key fob of your Nissan Juke is not working, check the battery for coins. It could be dead and need to be replaced. This is a simple fix that only takes less than a minute. It's as easy as flipping the fob upside down and opening the tiny latch/release at the back. Replace the battery that was in use and ensure it's facing the bottom of the fob. The two halves of the fob carefully.
If the fob has been exposed to water, it will need to be cleaned prior placing the new battery into. This can be done using a paper towel and isopropyl alcohol or electronic cleaner, and then allow it to dry completely prior to re-inserting the battery.
The key fob has to be connected with the vehicle in order to start it, which is done by following the instructions in the owners manual or an OBDII scanner. If the key fob is not been linked, it is the most likely reason of the reason it stopped functioning. It could also be that the fob has defective chip, however this is not common. In this situation the need for a new receiver module may be needed. If this is the case it must be replaced by a professional technician.
Water Damage
Key fobs operate on batteries and the batteries should be replaced every two years, or as soon as the vehicle stops responding when you push the "start" switch. The keys' rubber seals protect them from water, however submerging a key fob in the pool or ocean water could cause damage to the electronic chip. If this happens you'll have to purchase an alternative key from Nissan or a locksmith.
If the key's fob has functioning chips it's possible that the computer has lost connection to it, which can occur for a variety of reasons. It can be fixed by restarting the car. If the "Key ID error" message is still visible then you should contact Nissan for assistance.
The three most common reasons for this problem are dead batteries on key fobs as well as a key that is not programmed and a damaged or defective key fob that is damaged or defective. The first two issues are easy to resolve, and the third one is more difficult to fix on the spot, however it can usually be fixed with a bit of patience. WhoCanFixMyCar allows you to compare Nissan Key Replacement costs in your area and then book your repair. It only takes a few seconds and you can review customer reviews from local garages, Nissan car mechanics and dealerships before deciding.
Faulty Chip
The key fob of your Nissan Juke contains a special chip that transmits a signal to the vehicle whenever you turn it. The key could not function when the chip is damaged. In this case, you can only fix the problem by replacing the key. The Keylab could be faulty for several reasons, such as water damage or an inactive coin-battery.
If your key fob stopped working after a soak in the wash or bath, you need to check the chip for water damage. Make sure the metal retaining clips are tight and that the chip is not exposed to any water. If you notice any indications of water damage, consider removing the battery and then wiping the electronic component with isopropyl alcohol, or electronic cleaner.
If the chip is defective If the chip is damaged, you'll have to contact your local locksmith or dealer. To find a replacement, they will require the year, model and year of your car. It is also necessary to write down the VIN (Vehicle Identification Number) so that the locksmith or dealer can identify the key you have. This will allow them to find the correct key code and make sure that they are cutting the right one.
Faulty Receiver Module
The key fob transmits the radio frequency signal to your car that performs various functions. The key fob can open your trunk while you rush with your groceries to the car or even start your car by pressing the fob's button. It can also open your windows and turn the horn on when you accidentally lock the keys in your car.
If the key fob does not work, it may be due a problem in the receiver module. The receiver modules are tuned to receive specific frequencies that correspond with the signals transmitted by the Nissan key fob. A malfunctioning receiver module can hinder your car's response to the signal generated by the key fob of Nissan.
It's always a good idea to have a spare Nissan key fob in case your original key gets lost or breaks. A spare key can be programmed by a locksmith or a dealership to work with your Nissan and can help you avoid the stress of locking your keys inside your car or losing them.
If your Nissan Juke's key fob was exposed to rain or clean tap water, you can resolve the problem by cleaning it using isopropyl, or an electronic cleaner. If the chip has become damaged, you will need to purchase a new keyfob which can be programmed for your vehicle by a locksmith or dealer.